Epoxy Flooring in Ocoee, FL

Epoxy flooring in Ocoee runs on a humidity clock. Climate normals for the Orlando area show average relative humidity around 74 percent across the year, peaking near 79 percent in August, with July highs averaging 92 F. Resin chemistry reacts to all of that. Too much moisture in the air during cure can cause a cloudy film called blush, and a hot slab can make epoxy set before it levels.

How we work around the weather

On a muggy day we check air temperature, slab temperature and dew point before mixing anything. The slab needs to stay a few degrees above the dew point while the coating cures. We start early, keep batches small enough to spread before they kick, and pick primers and topcoats rated for warm, humid conditions.

Family garages that work hard

Ocoee grew from 24,391 people in 2000 to 47,295 in 2020, and about 54 percent of households are married couples. Many garages hold two cars, bikes, a freezer and a weekend project or two. A flake floor hides tire marks and dropped tools, and a polyaspartic topcoat resists hot-tire pickup, the problem where warm tires lift a soft coating right off the slab.

Get a Free Estimate

Highways that shaped the neighborhoods

State Road 50 opened in 1959, Florida's Turnpike in 1964, State Road 408 in 1990 and State Road 429 in 2000. Each new road brought a new ring of subdivisions, so Ocoee has garages poured in very different decades. An older slab near the original town may need crack repair and degreasing. A newer one off 429 might only need a grind and a moisture check.

Around Starke Lake

The original settlement grew up on the north side of Starke Lake in the 1850s, and the lake still anchors the older part of town. Homes near the water get the same moisture test as everyone else, and readings decide whether a mitigating primer goes down first.